Alexander
A.Shpilman ( sah@nursat.kz )
Shielding Packing
In the article "The
Simple "M-state" Elements Concentrators" the objects, sated by m-state elements,
are offered to store in a shielding case. But the goffered aluminium foil, used
in the design, is technologically difficult in manufacturing and in use. Besides
this, it occupies large volume.
In the article "the
Protection from axion fields radiations" (Russian) for shielding of "axion
fields" is offered to use large electrical potential of positive polarity.
This method can be used in the new design of a shielding case for storage of
objects, sated by m-state elements. But instead of metal walls with the large
voltage, we shall use the electrets pellicle - polymeric pellicle with the
large internal, volumetric positive charge (see fig.1).
|
If you have no electrets
pellicle you can make its analogue yourself (see fig. 2).
|
We put a polymeric pellicle
2 on a metal plate 1. We make a high positive voltage to an electrode 4
concerning a plate 1 such a way that on an edge of an electrode 4 the corona
discharge (but not spark!) light up. Arising at the corona discharge positive
charges will be injected deep into of polymeric pellicle.
Then pellicle 2 should be
covered by a similar polymeric pellicle 3. A plate 1 we remove, and we get a
laminate sandwich from two pellicles (it should be welded by heating). Of
course, it is necessary to choose a polymeric pellicle with small outflow of
charges.
If there is a problem with a source of a high voltage, it is possible to act
even easier. We put a clean, dry silk fabric and polymeric pellicle. We should
slightly rub them to each other. Then we cover a silk fabric on the other hand
by polymeric pellicle and laminate this sandwich from three layers. A laminated
silk fabric is ready.
Using such material it is
possible to make easily a shielding cylindrical case for storage of sticks from
colophony (rosin) or cornelian, charged by m-state elements (see A
Place of POWER").
In a Fig. 3 the shielding cylindrical case in cross section is shown. Where: 1
- stick from colophony, 2 - celluloid pellicle, 3 - four layers of a polymeric
grid, 4 - three layers of laminated silk, 5 - the iron case which thickness of
the wall is not less than 0.2 mm.
|
The polymeric grid is
intended for creation of an air gap between layers of laminated silk 3.
This method of shielding
can be used for shielding "geofield" and many versions of the
"axion field". If you make the electret fibre, it will be possible to
weave the electret cloth and to make protective clothes for a man. This method
will be effective if potential of a volumetric charge of the electret pellicle
and fibre will be more than longitudinal energy of the "axion field".
You can buy a complete set of
charged objects of "places power" with a shielding case. Information on E-mail: sah@nursat.kz |